Model G0853 (Mfd. Since 07/18)
-69-
6. Position leading edge of rip fence so it
extends across small extension table, as
shown in
Figure 138, then retighten lock
lever.
7.
Set rip fence to desired width of cut.
8. Load workpiece onto table saw. The setup
should look similar to
Figure 131 on Page 67.
9. Take all necessary safety precautions, con-
nect saw to power, then perform cutting
operation.
Figure 138. Proper position of rip fence.
Rip Fence
Lock Lever
Rip Fence
The Model G0853 can crosscut full-size pan-
els with the fence in the front or rear position,
although it is easier to load full-size panels with
the crosscut fence mounted in the front position
(see
Figure 139).
Crosscutting
Mounting the crosscut fence in the rear position
(see
Figure 140) gives greater stability for cross-
cutting smaller panels.
Figure 139. Crosscut with fence mounted in
front position.
Workpiece
Crosscut Fence
Edge Shoe
Workpiece
Figure 140. Crosscut with fence mounted in rear
position.
The edge shoe (see
Figure 140) is used to
stabilize the front end of the workpiece when
otherwise unsecured.
Summary of Contents for G0853
Page 24: ...22 Model G0853 Mfd Since 07 18 5mm Hardware Recognition Chart...
Page 140: ......
