Grizzly G0853, Owner'S Manual

Page: 62 / 140

-60-
Model G0853 (Mfd. Since 07/18)
6. Loosen support bar knob bolt shown in
Figure 114, slide support bar into position
required for operation, then tighten knob bolt.
3. Lift fence off table and roll it gently onto
its side so T-bolts (see Figures 111–112)
remain in same position.
4. Move fence to front or rear position, and
insert T-bolt into front hole or rear pivot hole,
and insert angle scale bar T-bolt into angle
scale bar slot.
Figure 111. Location of front and rear pivot
holes and pivot knob T-bolt.
Front Pivot Hole
Rear Pivot Hole
T-Bolt
Figure 112. Location of angle scale bar and
T-bolt.
Angle
Scale Bar
T-Bolt
5. Rotate fence so 0° stop block is up against
stop bolt (see
Figure 113), then rotate latch
into catch and secure by tightening knurled
thumb knob.
Figure 113. Stop block against 0° stop bolt.
Latch 0° Stop Block
Stop Bolt Catch
Figure 114. Location of knob bolt for adjusting
support bar position.
Support Bar
Knob Bolt
Positioning Crosscut Table Along
Sliding Table
The crosscut table can be positioned as neces-
sary along the sliding table (see
Figure 115).
Figure 115. Crosscut table positions along
sliding table.