GRAPHTEC CUTTING PRO FC3100-60, Service Manual

Page: 24 / 175

FC3100-60 Service Manual
P/N53802-031T Rev. A
2 - 14
2.8 Selecting the Command Mode
This function selects the command mode for the plotter.
Note : Be sure to set the command mode to match the command mode setting of your software
application.
Procedure
[ PAUSE ] : Press the [ PAUSE ] key to select PAUSE mode.
↓
[ NEXT ] : Press the [ NEXT ] key.
↓
[ NEXT ] : Press the [ NEXT ] key again.
↓
[ 1 ] : Press the [ 1 ] key to select INTERFACE.
↓
[ 4 ] : Press the [ 4 ] key to select COMMAND.
↓
The sub-menu below appears, so select the desire command mode.
To select GP-GL command mode, press the [ 2 ] key to shift the blinking cursor to the left.
To select HP-GL command mode, press the [ 4 ] key to shift the blinking cursor to the right.
↓
[ ENTER ] : Press the [ ENTER ] key to register your setting.
↓
[ PAUSE ] : Press the [ PAUSE ] key to cancel PAUSE mode.
Note : Your COMMAND setting is retained in the plotter's internal memory even while the plotter is
turned off.