GRAPHTEC CUTTING PRO FC3100-60, Service Manual

Page: 58 / 175

FC3100-60 Service Manual
P/N53802-031T Rev. A
4 - 22
4.2.8 Replacing and Adjusting the Pen Block
Replacing the Pen Block
(1) Remove the top cover (see Subsection 4.1.3).
(2) Remove the pen block cover as shown in Fig.4-50.
•
Two M2 x L8 bind-head screws
Fig. 4-50
(3) Remove the FPC cable guide as shown in Fig.5-51.
•
Two M2 x L4 bind-head screws
* The screw may become stuck to the MC coil.
* Be careful not to scratch the slide shaft.
Fig. 4-51
(4) Disconnect the pen block FPC cable from the PR216013 pen board's J32 connector.
(5) Remove the pen block as shown in Fig.4-52.
•
Make sure not to damage the pen block FPC cable.
•
Two M3 x L6 bind-head screws
Fig. 4-52