GRAPHTEC CUTTING PRO FC3100-60, Service Manual

Page: 7 / 175

FC3100-60 Service Manual
P/N53802-031T Rev. A
1 - 3
1.2 Daily Maintenance and Storage
1.2.1 Daily Maintenance
During the course of daily plotter operation, be sure to observe the following precautions.
•
Never lubricate the mechanisms of the plotter.
•
If the plotter's casing becomes dirty, wipe the soiled areas using a dry cloth or a cloth that has been
moistened in a neutral detergent diluted with water.
Never use thinner, benzene, alcohol, or similar solvents; they will damage the casing's finish.
•
If the cutting mat becomes dirty, wipe the soiled areas using a dry cloth. In case of stubborn stains, use
a cloth that has been moistened in alcohol or in a neutral detergent diluted with water.
•
The correct functioning of the paper size sensors is obstructed by the adhesion of dust, dirt, or other
foreign matter. Keep the sensors clean by wiping them with a cloth moistened in alcohol or in a
neutral detergent diluted with water.
Never use benzene, thinner, or similar solvents to clean the sensors.
1.2.2 Storing your Plotter
To store the plotter when it is not being used, be sure to observe the following points:
•
Remove the pen attached to the pen holder and cover its tip with the protective cap provided.
•
To protect the plotter from dust and dirt, cover it with a cloth.
•
Avoid storing the plotter in places subject to direct sunlight or high temperatures.