GRAPHTEC CUTTING PRO FC3100-60, Service Manual

Page: 23 / 175

FC3100-60 Service Manual
P/N53802-031T Rev. A
2 - 13
Consecutively press the [
⇑
] or [
⇓
] key to cycle through the available choices in the sequence below.
→
No.=1
↔
No.=2
↔
No.=3
←
|
_________________________
|
When the number of the desired group is displayed, press the [ ENTER ] key. The menu similar to the
example below appears.
Press the numeric key next to the condition you wish to change. The selected condition blinks to indicate
that you can change its setting, so press the [
⇑
] or [
⇓
] key until the desired value appears.
To set the rate of data transfer, press the [ 1 ] key. Next, consecutively press the [
⇑
] or [
⇓
] key to cycle
through the available speeds in the sequence below.
→
300
↔
600
↔
1200
↔
2400
↔
4800
↔
9600
←
|
_________________________________________
|
To set the number of bits per character, press the [ 2 ] key. Next, press the [
⇑
] or [
⇓
] key to select 7 or
8 bits.
→
7
↔
8
←
|
_________
|
To set the parity mode, press the [ 3 ] key. Next, press the [
⇑
] or [
⇓
] key to cycle through the available
choices.
→
N(No parity check)
↔
E(Even parity)
↔
O(Odd parity)
←
|
_________________________________________________
|
To set the handshaking mode, press the [ 4 ] key. Next, consecutively press the [
⇑
] or [
⇓
] key to cycle
through the available handshaking modes.
→
H(Hardwire)
↔
X(X on/X off)
↔
E(Enq/Ack)
←
|
__________________________________________
|
E(Enq/Ack) only appears when HP-GL
TM
command mode has been selected.
↓
[ ENTER ] : When the displayed settings are all correct, press the [ ENTER ] key to register your
settings.
↓
[ PAUSE ] : Press the [ PAUSE ] key to cancel PAUSE mode.
Note : Your settings are retained in the internal memory even while the plotter is turned off.