GRAPHTEC CUTTING PRO FC3100-60, Service Manual

Page: 108 / 175

FC3100-60 Service Manual
P/N53802-031T Rev. A
5 - 12
5.11 Overall Adjustments
Note :
•
After all mechanical and electrical adjustments are completed, use the gain adjustment
program to check the main axes servos and for fine adjustment of the X and Y motor offsets.
•
Set the CONDITION PRIORITY function described in Section 2.6, "Using the Special
Functions," to PROGRAM.
•
Set the programmable resolution to 0.100 mm.
(1) Connect the plotter to the computer via an RS-232C interface cable, making sure that the cable is
connected properly.
(2) Revise the gain adjustment program for the FC3100-60 as follows.
FC2100-60A FC3100-60
SPG 5 5
Traveling distance 300 x 300 300 x 300
SS, AA 60, 30 60, 30
(3) After inserting the floppy disk in the computer's disk drive, load and run the program.
(4) When the program is booted, the wave-form shown below appears on the computer's monitor.