GRAPHTEC CUTTING PRO FC3100-60, Service Manual

Page: 88 / 175

FC3100-60 Service Manual
P/N53802-031T Rev. A
4 - 52
Caution : Do not install the plotter on to the Accuload
TM
Film Stocker Bracket before installing the Film
Stocker Bracket on to the Stand. The extra weight from the plotter may cause the unit to
become unstable. In extreme cases, the unit may tip over !!
4.5.3 Mounting the Plotter on the Stand
Remove the Accuload
TM
Film Stocker Bracket
To remove the Accuload
TM
Film Stocker Bracket from the Plotter, follow the directions below.
(1) Remove the Roller Bars from the media bracket.
(2) Remove the screws holding the Film Stocker Bracket to the plotter and slide the plotter off the
bracket.
Fig. 4-116
(3) If there is Media Bracket attached, remove the two rubber feet from the front two media brackets as
shown using the Phillips screwdriver.
Fig. 4-117
Install a new Accuload
TM
Film Stocker Bracket
To install a new Accuload TM Film Stocker Bracket, follow the directions below.
(1) Lay the assembled Film Stocker Bracket on a flat surface and cheek for flatness.
(2) If the Film Stocker Bracket is skewed, loosen the 6 screws holding the 3 Stiffener Rods. Make sure
the bracket is lying flat.
Fig. 4-118