GRAPHTEC CUTTING PRO FC3100-60, Service Manual, Page: 96 / 175

FC3100-60 Service Manual
P/N53802-031T Rev. A
4 - 60
(6) Check that the groove is free from glue and dirt. Clean off any dirt or glue with a cloth moistened in
ethyl alcohol.
Fig. 4-140
Caution : If you perform pouncing on a cutting mat instead of the special pouncing mat, the holes may
not pounce correctly and you may damage your plotter. Be sure to replace the cutting mat with
a pouncing mat before beginning a pouncing operation. Always reinstall cutting mat before
beginning a cut operation.
Installing the Pouncing Mat
(1) Remove the backing sheet from the underside of the pouncing mat.
(2) Move the pen carriage to the right of the plotter.
(3) Starting from the left side of the plotter, align the mat with the rear edge of the groove (leave 2-3 mm
gap between the side plate and the mat), then carefully attach the mat. Take care that the mat does
not buckle, and work with a small area at a time.
(4) When you reach the center, move the pen carriage to the left before attaching the rest of the mat.