Good Will Instrument GKP-2302, User Manual

Page: 96 / 249

GKP-2302 User Manual
82

Sequence Control View (output on state/sequence stopped)
Measured Value to be
displayed
Output setting of
step No.0
Icon
Figure 4-10 Sequence Control View (Output On State/Sequence Stopped)
4.3 Using Power Fluctuation Testing (Simulation) Function
4.3.1 Basics
The Power fluctuation testing (Simulation) function allows you to edit and output voltage
patterns that simulate power line anomalies such as blackout, voltage rise, voltage drop, abrupt
phase change, and abrupt frequency change. This section describes the basics for using the
Simulation function.

AC/DC Mode and Signal Source
Simulation function sets the AC/DC mode and a signal source, independently from continuous
output function/Sequence function. The setting is fixed to ACDC-INT.

Keep simulation setting file
The simulation setting is cleared when the power is turned off. To save the setting, you need to
save it in internal memory or USB memory (see
4.9
).

Step
The output by the Simulation function consists of six types of steps: Initial, Normal 1, Trans 1,
Abnormal, Trans 2, and Normal 2. Before the simulation starts, GKP-2303 stands by at the
Initial Step. During the simulation, the step changes in the order of Initial, Normal 1, Trans 1,
Abnormal, Trans 2, and Normal 2. After the simulation ends, GKP-2303 returns to the Initial
Step and stands by.

Step parameter
Each parameter of Step Time, AC voltage, frequency, start phase, stop phase, trigger output,
and synchronization output can be set for each step. However, some parameters cannot be set