Good Will Instrument GKP-2302, User Manual

Page: 74 / 249

GKP-2302 User Manual
60
Figure 4-3 Stop Phase
--------
Notes
----------------------------------------------------------------------------------------------------------------

When the Step Behavior is set to [Sweep], output is constant while waiting for the step
Stop Phase after the Step Time passes.

Step Stop Phase setting can be disabled. In this case, when the set Step Time has passed,
the execution transitions to the next step without waiting for step Stop Phase.

In DC mode, the step Stop Phase cannot be set.
---------------------------------------------------------------------------------------------------------------------------------

Trigger output (Trig Out)
State output to CONTROL I/O connector. This specifies whether the trigger output presents
when the step starts. Polarity and pulse width of the trigger output complies with the trigger
output setting (see
4.2.5
).
4.2.3 Example of Output Using Sequence Function
As an example, consider the sequence that gradually changes DC voltage like Figure 4-4.
Set the output mode to DC-INT. Edit the sequence like Table 4-3. Parameters not included in
this table should be left as the factory default setting.
O
u
tp
u
t
v
o
lt
a
g
e
Time
Start operation Stop operation
Figure 4-4 Example of Sequence
Table 4-3 Example of Editing Sequence
Step Number
0 1 2 3
Step-contro
l parameter Step Time (Time)
5 s 20 s 10 s 15 s
Jump-to (Jump To)
— OFF OFF OFF
Step termination (Step
Term)
— Continue Continue Hold
Intra-Step
Parameter DC Voltage (DCV)
0 V +100 V (Optional) +50 V
Step Behavior
Sweep Sweep Keep Const
--------
Notes
----------------------------------------------------------------------------------------------------------------

Step Time and the Step Behavior of step No. 0 specifies the action after the transition to
step No. 0 at the end of a sequence.

Jump-to of step No. 0 cannot be specified. The execution always transitions to step No. 1