GILES EOF-20/20, Operation & Service Manual

Page: 19 / 102

7
EOF-20/20 EOF-20/20
2-04. Electrical Connections
1. Install appropriate Circuit Breakers in Main Breaker Box! See Table 2-04.
2. Connect Flexible Conduit from Main Breaker Box to Quick Disconnect Box.
3. Connect Flexible Conduit from Quick Disconnect Box to the Fryer. Allow enough Conduit so Fryer can
be moved away from the wall for cleaning and servicing. See Figure 2-05.1.
4. Open Fryer Door and remove Service Box Cover. See Figure 2-05.1.
5. Connect the electrical ground wire between the Terminal Block Ground Lug and a proper earth ground.
6. Route appropriate size Power Wires to the Fryer.
7. Connect the Power Wires to the appropriate Terminal Blocks located in the Service Box. See Figure 2-
04.1.
8. Reinstall Service Box Cover and close the Fryer Door.
2-03. Electrical Requirements
The EOF-20/20 is available from the factory in the voltages and phases listed below. Check the rating plate on
the rear of the fryer to determine the correct power supply.
•
Fryers must be adequately and properly grounded. Improper grounding may result in electrical
shock. Always refer to your local electrical code to ensure proper grounding of this or any other
electrical equipment. Always consult with an electrician or other qualified service person to ensure
breakers and wiring are of sufficient rating and gauge for the equipment being operated.
!
CAUTION
2-03.1. EOF-20 Electrical Specifications
Voltage Phase Watts
Circuit Breaker
required
Amps
L1 L2 L3
208 1 24,000 115 115 --- 150
208 3 24,000 72 46 72 80
240 1 24,000 100 100 --- 125
240 3 24,000 68 44 68 75
480 3 24,000 34 22 34 50