Page C-12
MDE-4699L Applause™ Media System Installation, Service, and Parts Manual · June 2017
Configuring Site Server IP Addresses for Applause
Media System (when IP Addresses Are Changed)
Configuring Static IP Address on Your Laptop
Configuring Static IP Address on Your Laptop
If the current IP address at any device (site server and dispensers) does not match the IP
scheme that needs to be used, follow the instructions to change the IP address on your laptop
to the required IP address scheme.
You need to have your laptop connected to the device with an Ethernet network
connection (CAT-5 cable).
IMPORTANT INFORMATION
For example, if the required dispenser IP scheme is 10.5.48.71, 10.5.48.72, and 10.5.48.73,
and there is a dispenser (1 and 2) with an IP address of 10.128.46.71 (side 1) and 10.128.46.72
(side 2), you may need to change that IP scheme.
Note: This procedure may vary slightly depending on your laptop’s operating system.
To set the static IP address on your laptop, proceed as follows:
1
Right-click
My network Places
.
2
Select
Properties
.
3
Right-click on your local area connection. (for example, COM1 or local area connection)
4
Select
Properties
.
5
Select
Internet Protocol TCP/IP
from the list of options.
6
Select
Properties
.
At this point, you require to program the address scheme that currently exists at the dispenser
you want to change.
7
Click
Use the following IP address
.
8
Program the IP address to 10.128.46.240. Retain the subnet mask at 255.255.255.0 and then
select
Ok
>
Ok
.
9
You must be able to open up Internet Explorer and type in 10.128.46.71. This must bring up
that dispenser (1 and 2). You can change the IP address for both sides of the dispenser to
(10.5.48.71 and 10.5.48.72) and then submit the changes.
10
Repeat steps
, change the laptop IP address to 10.5.48.240. This will set that
laptop on the same IP scheme as the dispenser and will allow you to connect to it just as you
connect to other dispensers.
