MDE-4699L Applause™ Media System Installation, Service, and Parts Manual · June 2017
Page C-5
Configuring Site Server IP Addresses for Applause
Media System (when IP Addresses Are Changed)
4
Click
Network Settings
. The Network Settings screen appears. Make the required changes
under Ethernet Settings.
Figure C-5: Site Server
Note: The settings shown in this figure are the Gilbarco default IP address settings. The default
value for Dispenser Download Bandwidth Limitation is 1 MB/s. Usually, this value does not
need to be modified.
5
Select
Continue
at the bottom of the screen.
6
Click
Apply New Settings
on the next screen after you have reviewed the settings, and follow
the instructions to reboot the server.
Note: You will be prompted to reboot the server two times. Record your settings for later use.
If the entire IP address scheme at the site needs to be changed, then the dispenser IP addresses
will also need to be reprogrammed to match the site server. This can be done through CRIND
diagnostics or a laptop connected to the LRE or a router.
Note: If there are any problems during this process, consult ASC.
