Processor
Configuration
Memory
population
Memory
population
information
Mirroring population order
A{1, 2, 3, 4, 5, 6},
B{1, 2, 3, 4,
5, 6}
Mirroring is supported
with 6 DIMM slots per
processor.
Single rank sparing population order
A{1}, B{1}, A{2}, B
{2}, A{3},
B{3}...
Populate in this order,
odd amount per
processor allowed.
Requires
two ranks or more per
channel.
Multi rank sparing population
order
A{1}, B{1}, A{2}, B
{2}, A{3},
B{3}...
Populate in this order,
odd amount per
processor allowed.
Requires
three ranks or more
per channel.
Processors and heat sinks
This describes the procedure to install and remove Processors and Heat Sinks.
WARNING:
The heat sink may be hot to touch for some time after the system is powered
down. Allow the heat sink to cool before removing it.
l
Follow the safety guidelines listed in
l
Follow the procedure listed in
Before working inside your system
l
If applicable, remove the air shroud.
Removing Processor and Heat Sink Module
Follow the below steps to remove a Processor and Heat Sink module:
1. Using a Torx #T30 screwdriver, loosen the screws on the heat sink in the order below:
a. Loosen the first screw three turns.
b. Loosen the second screw completely.
c. Return to the first screw and loosen it completely.
2. Pushing both blue retention clips simultaneously, lift the processor and heat sink
module (PHM) processor and heat sink module
3. Set the PHM aside with the processor side facing up.
Contents
41
GigaVUE-FM Hardware Appliance Guide for GFM-HW1-FM010
