[Camera Status Icon]
:
On standby
:
Enabled for motion detection and input trigger
: Recording is on.
[Recording Settings]
Note this function is only supported by
GV-FER5700 / 12203 /
EFER3700 / EFER3700-W
firmware V1.02 or later. Configure recording settings for motion
and I/O events, and the condition to record.
Pre-alarm recording time:
Activates video recording before an event occurs. Set the
recording time to 1 or 2 seconds. The recording is saved in the buffer of the camera.
Post-alarm recording time:
Activates video recording onto the inserted memory card
after an event occurs. Set the recording time from 1 to 30 seconds.
Split-interval:
Sets the time length between each event file from 1 to 5 minutes.
Recording Profile:
This setting is only applicable for recording to the camera’s memory
card. Select
Performance
to maximize the lifespan of the memory card by restricting the
frame rate to 30 fps and maximum bit rate to 4 Mbit. Select
Quality
to adopt your current
settings. The default setting is
Performance
.
Record audio:
Activates audio recording when an event occurs.
Recording Policy:
By default, the camera will only record to the memory card when the
camera is not streaming live view to other applications (e.g. GV-VMS) or Web browser.
Alternatively, you can set the camera to always record to the memory card as a
secondary backup.
Note:
When the camera is recording to the memory card, it is recommended to connect no
more than two connections to the camera using Web interface or other applications
132
Summary of Contents for GV-FE3402
