Geko 12V 4000 G 41, Operating Instructions Manual

Page: 95 / 124

Oil Filtration / Cooling 37
6.14.2 Centrifugal oil filter cleaning and filter-sleeve replacement
Preconditions
Engine is stopped and starting disabled.
Special tools
Designation / Use Part No. Qty.
Strap wrench TC
Material
Designation / Use Part No. Qty.
Cleaner Hakutex 60 FLS
Spare parts
Designation / Use Part No. Qty.
Filter sleeve SPC
Sealing ring SPC
Sealing ring SPC
WARNING
Hot engine oil.
Engine oil can contain combustion residues which are harmful to health.
Risk of injury and scalding!
Wear protective clothing, gloves, and goggles / safety mask.
Avoid contact with skin.
Do not inhale oil vapor.
WARNING
Compressed air.
Risk of injury!
Do not direct compressed-air jet at persons.
Wear protective goggles / safety mask and ear protectors.
Centrifugal oil filter cleaning and filter-sleeve
replacement
1. Remove clamp (3).
2. Release Tommy nut (1) and take off cover (2).
3. Carefully remove rotor (5) from housing.
4. Remove knurled nut (7) on rotor cap, holding the
rotor with strap wrench.
5. Take off rotor cap (8).
6. Remove filter sleeve (9) and stiffener plate (10).
7. Measure thickness of oil residues on filter sleeve.
8. If maximum layer thickness of oil residues
exceeds 30 mm, shorten maintenance interval.
9. Remove sealing ring (11) and standpipe (12).
10. Wash cover (2), rotor cap (8), stiffener plate (10),
standpipe (12) and lower rotor section (13) with
cleaner and blow out with compressed air.
11. Fit new sealing ring (11) on rotor lower section
(13).
M015403/00E 02-09 © MTU
www.generent.ru