Geko 12V 4000 G 41, Operating Instructions Manual

Page: 77 / 124

Fuel Injector 19
11. Use slotted screwdriver to check thrust ring at
both line ends for secure seating.
12. Tighten loose thrust ring to 10 Nm.
13. Fit hold-down clamp (1) in correct position and
install screw (2) by hand.
14. Tighten screw (2) with torque wrench, preliminary
tightening torque: 5 Nm to 10 Nm.
15. Coat new O-rings (4) and (6) on with petroleum
jelly and fit on HP fuel line (5).
16. Install HP line (5) and tighten preliminarily,
tightening torque: 5 Nm to 10 Nm.
17. Tighten screw (2) to 100 + 10 Nm.
18. Tighten HP fuel line to 120 Nm + 12 Nm.
19. Fit cable terminals below the screws on injector
and tighten to 1 Nm.
M015403/00E 02-09 © MTU
www.generent.ru