IST-1408.PA01.02 - Dis.0534045
CE408P / User Manual
Pag. 2/41
GECA S.r.l. - Via E. Fermi, 98 25064 GUSSAGO (BS) - Tel. 030 3730218 - Fax 030 3730228
Please read and keep care of this manual and the manual of
installed sensors too.
All documentation relating to gas detection plant should be preserved, because it
contains the procedures to be used during the routines verification and / or during the
periodic calibration. We recommend that you always complete the
Setup Memorandum
Tables
in the last pages of this manual
. This will facilitate any possible change to the
configuration and/or in case of additional sensors, and operations and maintenance service
INFORMATION AND WARNINGS OF USE
The CE408 is a control unit for gas alarm systems up to 8 independent detection points. The
simple installation and easy configuration via the buttons make the unit suitable for use in
many areas, both civil and industrial.
It should be noted that inappropriate use or lack of maintenance can affect the operation of the
device and thus preventing the proper activation of alarms with potential serious
consequences for the user.
GECA disclaims any responsibility if the product is misused, altered or not as planned or put in
work incorrectly. The choice and use of the product are the sole responsibility of the individual
operator.
The rules, laws, etc.. mentioned, are the ones valid on the date of issue. In any case, must be
observed all applicable national regulations in the country of use.
The information contained in this document is accurate, current, and are the result of
continuous research and development, the specifications of this product may be changed at
any time without notice.
The Central has a clock with the automatic DST change. In the absence of power
supply, the clock works with the lithium battery (on the board in the cover), its life, in
normal operation is over 5 years.
If the lithium battery is exhausted and the central remained completely without power, at
startup, you will need to enter the correct date and time
(
see page 29
) and then the battery must
be replaced soon with a new one.
NOTES FOR READING INSTRUCTION
CE408P
Central control unit for 4 Gas Sensors, expandable to 8 with ES404, with no.5 relay
outputs, expandable to 9 with ES4014 and 1 Logic Input.
ES404
Expansion card with no.4 inputs (4-20mA) for gas sensors.
ES414
Expansion card with no.4 relay outputs.
SENSOR
It is the name that, for simplicity, are indicated the various models of Remote Gas
Sensors, with current output 4 to 20mA, that can be connected to the CE408P.
FIRMWARE
Program inserted into the microcontroller which controls CE408P functioning.
Symbol that indicates an important warning in the instructions.
Symbol indicates information or additional explanation in the instructions.
Documento / Document name:
IST-1408.PA01.02_CE408-EN (02.04.2014).docx
Oggetto / Subject :
CE408P
/ Wall monut Central Unit
Rev.
Data / Date
Da / By
Note
0
02/04/2014
UT/AS&FG
Document Edition
