IST-1408.PA01.02 - Dis.0534045
CE408P / User Manual
Pag. 24/41
GECA S.r.l. - Via E. Fermi, 98 25064 GUSSAGO (BS) - Tel. 030 3730218 - Fax 030 3730228
If this procedure is correct, a window notifies you that the operation has
been successful. -----------------------------------------------------------------------
Then the screen returns the beginning of the management the Enable or
Disable.
CONFIGURE (Level 2)
: Press
ENTER
on the item to configure the Logic Input.
For safety, the outputs are configurable only in configuration or modification of a Sensor, a
Logic Input or a Zone. You cannot configure the outputs separately.
Press
ENTER
to configure the Logic Input. -----------------------------------------
It is recalled that the central CE408P, has only one logic input.
Use
and
to scroll through the various items and then pressing
ENTER
is highlighted only the value, indicating that you can change it. -----
Then use
and
values are changed, while
and
goes
from field to field on the same line (
where applicable
) and then pressing
ENTER
the change is accepted.
While pressing
ESC
restores the previous value and the entire line is
highlighted, indicating that you can only scroll through the items. The following explains the various
items in detail.
Description of items relating to Logic Input:
ACTIVE:
Indicates how we consider, activated the entrance.
LOW
means that it is active when it is
short-circuited (
e.g. pushbutton
).
HIGH
means that it is active when open.
Description of items relating to Outputs (relays):
This description is the same as one written in the chapter CONFIGURE SENSORS. Please see
page 16
(OUTPUT N, SILENCEABLE, SILENCE T., DELAY ON, DELAY OFF/TIME ON, POS.LOGIC, LATCHED).
At the end of the screen, is written
SAVE
, to save the configuration
inserted. Pressing
ENTER
the confirmation window will appear. Press again
ENTER
to confirm. In case you want to go back, press
ESC
.
After having confirmed, a window notifies you that the operation has
been successful. -----------------------------------------------------------------------
Then the screen returns the beginning of the management Configure
Logic Inputs.
INPUT CONFIG.
INPUT N.
1
INPUT CONFIG.
INPUT N.
1
ACTIVE
:
LOW
OUTPUT N.:
0
SILENCE MODE :
NO
SILCENCE T. :
0s
DELAY ON :
0s
DELAY OFF :
0s
INPUT CONFIG.
INPUT
N. 1
CONFIGURED
ENABLE
INPUT
N. 1
ENABLED
