IST-1408.PA01.02 - Dis.0534045
CE408P / User Manual
Pag. 26/41
GECA S.r.l. - Via E. Fermi, 98 25064 GUSSAGO (BS) - Tel. 030 3730218 - Fax 030 3730228
To
enable
or
disable
a zone, press the
ENTER
key on the relevant item.
With
and
it is possible to select, if you take action on a single
zone or on a group of Zones. -------------------------------------------------------
The first line, is acting on a single Zone. Pressing
ENTER
on the first line,
will highlight the number of the zone. Then with
and
you
choose the desired number and pressing
ENTER
the confirmation window
will appear.
The second line, acts on a group of Zones, pressing
ENTER
on the second,
will highlight the first zone’s number of the group. -----------------------------
You can
enable
or
disable
all Zones, including between two, both from the smallest to the
largest number, and the reverse.
With
and
key, you can choose the number of required Zone,
pressing
and
you change from one value to another and then
pressing again
ENTER
confirmation window will appear. ------------------------
Press
ENTER
to confirm or in case, you want to go back, press
ESC
.
If the zone or one of the group’s Zones is not configured, a window
notifies you that the operation is not possible. ----------------------------------
Then the screen returns to the selection of the Zone.
If you have selected a group of Zone, the ones that have been
configured are enabled or disable. Dialog box appears to warn
you that you have selected one or more zones are not
configured
If this procedure is correct, a window notifies you that the operation has
been successful. -----------------------------------------------------------------------
Then the screen returns to the beginning of the management for Enabled
or Disable.
CONFIGURE (Level 2)
: Press
ENTER
on the item to configure a Zone.
For safety, the outputs are configurable only when configuring or changing a sensor, a logic
input or a zone. You cannot configure the outputs separately
Using the
and
keys and pressing
ENTER
you can choose the
Zone’s number to be configured.---------------------------------------------------
Then, use the
and
key, to scroll through the different items.
Pressing
ENTER
on the item, the value is highlighted to indicate that it is
editable. ----------------------------------------------------------------------------------
Use
and
to change the value, using
and
you change
from to another field in the same row (
where applicable
). Then pressing
ENTER
the change will be accepted. Pressing
ESC
will restores the
previous value and the entire row is selected, indicating that you can
only scroll through the items.
ENABLE
ZONE N.
FROM N. TO N.
ENABLE
ZONE N.
FROM N. TO N.
ENABLE
CONFIRM ?
YES = ENTER
NO = ESC
ENABLE
ZONE
N. 1
NOT CONF.
ZONE CONFIG.
ZONE N.
1
ZONE CONFIG.
ZONA
N.
1
LOGIC :
AND
OUTPU_1_THRESH_1
OUPUT N. :
0
SILENCE MODE :
NO
SILENCE T.
:
0s
IST.ON
:
0s
ENABLE
ZONE
N. 1
ENABLED
