GE CARESCAPE Monitor B850, Service Manual

Page: 135 / 192

Maintenance and checkout
127
2106778-001
2. Select Information > Device Information .
3. Verify that the information about the connected module appears in the table named as
“Acquisition Information – E-Modules” .
NOTE: For some parameter modules, the table does not show the actual module information,
but the information of the individual subassemblies inside the module.
NOTE: You may need to refresh the Webmin screen if you have connected the module to the
patient monitor after entering the
Device Information Webmin screen.
10.3.5 Keypad and remote
Follow the procedure in section 8.3.5. Trim knob, keypad, and remote .
10.3.6 Mouse
Follow the procedure in section 8.3.6. Mouse .
10.3.7 Alphanumeric keyboard
Follow the procedure in section 8.3.7. Alphanumeric keyboard .
10.3.8 Barcode reader
Follow the procedure in section 8.3.8. Barcode reader .
10.3.9 MC Network and S/5 Network
Follow the procedure in section 8.3.9. MC Network and S/5 Network .
10.3.10 IX printers
Follow the procedure in section 8.3.10. IX printers .
10.3.11 InSite RSvP
Follow the procedure in section 8.3.12. InSite RSvP .
10.3.12 Recorder
1. Select Monitor Setup > Printing > Devices > Setup and configure:
Printout: Waveforms
Location: Local
2. Select Monitor Setup > Printing > Waveforms and configure:
Waveform 1: II
Waveform 2: V1
3. Select one of the following options to start printing:

Select Print Waveforms from the main screen.

Select Monitor Setup > Printing > Waveforms > Print Waveforms .