GE HEALTHCARE CARESCAPE Monitor B650, Technical Manual

Page: 122 / 240

CARESCAPE Monitor B650
114
2062973-002
NOTE: Make sure that at least one other patient monitor is on the network. The other patient
monitor must be in an admitted state and have an active ECG measurement with a simulator
signal.
1. Disconnect the network cable from the MC Network connector, if connected.
2. Check that the wireless network symbol and the signal strength symbol are shown
and that the signal strength is adequate.
3. Select Data & Pages – Other Patients and select a patient from the list.
4. Select View and verify that a window with parameters from another patient displays on
the left side of the screen.
5. Select Close View to close the window.
6. Reconnect the MC Network cable back to the MC Network connector, if applicable.
8.3.11 IX printers
Perform the following test only if the patient monitor is connected to a printer in the IX Network
and you did not print a test page while you configured the IX printer.
1.
Log in to Webmin.
2. Select Configuration > Printers > Print Test Page .
3. Select the IX Printer to test.
4. Select Save .
5. Verify that the test page was printed to the selected printer.
6. Repeat steps 3 to 5 for all connected IX printers.
8.3.12 Insite with EXC
Perform the following test only if the remote service is configured and enabled.
•
Contact your local online support center to find out if they can view the patient monitor.
8.3.13 Test completion
Discharge Patient or Reset Case to discard any changes made to the patient monitor
configuration during checkout.
• Complete the Appendix A. Installation check form .