GE HEALTHCARE B20, User'S Reference Manual

Page: 118 / 320

B40/B20 Patient Monitor
6-14
Changing the recorder and printer settings
Recorder settings
1. Press
Print/Record
.
2. Select Record Waveforms.
•
Select Waveform 1 and select a parameter or select OFF . Then select Waveform 2
and Waveform 3 and their parameters. You can record up to three waveforms
simultaneously. If you wish to record only one waveform, select the other waveform
fields
OFF .
•
Select Start on Alarms - Yes to start automatic strip chart recording when the
following alarms reach the red alarm level ( NO is the default):
−
with VSP software license: bradycardia, tachycardia, asystole, Art high/low, V
Fib, V Tach
•
Select Delay and OFF or 12 s . If the recording delay is OFF , the recording starts when
an event occurs and continues for 30 seconds or until manually stopped, or until the
recorder runs out of paper. If the delay is
12 seconds (default), the recording starts
when an event occurs and the 12 seconds prior to the event are recorded from the
recorder memory. The recording continues for 18 seconds if the length has been set
to 30 seconds or until the recorder runs out of paper.
•
Select Paper Speed and 1 , 6.25 , 12.5 , or 25 mm/s (default).
•
Select Length and choose 30 s (default) or Cont .
Print/
Record