44
Note:
Most fruit and vegetables such as small apples, carrots and cucumber will
not need to be cut to size as these will fit into the feed chute whole. When juicing
carrots place the tip of the carrot into the feed chute last.
Step 2:
Ensure the juicer is correctly assembled. Ensure the stainless steel filter is thoroughly
cleaned before each use (refer to ´Care and cleaning`). Ensure you place the juice
jug under the spout before commencing juicing.
Step 2 a: Working with the juice jug
The juice jug consist of the jug with scale, a froth seperator
and the lid. Insert the froth separator from the top into the
jug and close the jug with the lid. Place the juice jug infront
of the spout and ensure that the juice can run right into the
jug. This way you can avoid splatter.
ATTENTION:
Ensure not to overfill the juice jug when
operating the juicer. Over floating liquid could run under the
motor block and cause damage to the appliance.
Step 3:
Plug the power cord into a 220/230V power outlet and turn the power ‘ON’. Push
the ‘ON/OFF’ button to ‘ON’.
Step 4:
With the motor running, place food into the feed chute. Using the food pusher, gently
guide food down the feed chute. To extract the maximum amount of juice, always
push the food pusher down slowly.
Step 5:
Juice will flow into the jug and the separated pulp will accumulate in the integrated
pulp container.
ATTENTION:
Do not allow the pulp container to overfill as this may affect the
operation of the appliance (refer to disassembling instructions). Reassemble machine
to continue juicing.
To minimise cleaning, line the pulp container with a plastic freezer bag to collect the
pulp. Empty the pulp container during juicing
The pulp container can be emptied during juicing by turning the appliance ‘Off’ at
the control panel and then carefully removing the pulp container. Remove the pulp
Summary of Contents for Design Juice
Page 32: ...32...