42
ASSEMBLING YOUR DESIGN JUICER
Step 1:
Place the filter bowl surround on the motor block (1).
Step 2:
WARNING:
Handle the units with care and do not
use any force. Pay attention to the sharp blades on the
stainless steel micro mesh filter and the feed chute to avo-
id injury. Always completely assemble your juicer before
you plug the plug into the power point.
ATTENTION:
Ensure the stainless steel filter basket is
clean before assembling. Any dehumidified left over food
on the basket will block the fine mesh holes. If necessary
remove excess fibre build up (from fruit or vegetables)
according to the instructions ´Care and Cleaning`.
Align the arrows on the stainless steel filter basket with the
arrows on the motor drive coupling and push down until
it clicks into place. Ensure the stainless steel filter basket
is fitted securely inside the integrated pulp container and
onto the motor base (2).
Step 3:
Place the juicer cover over the stainless steel filter on top
of the filter bowl surround (3). The feed chute has to be
positioned in the middle of the filter basket and the pulp
spouting of the cover has to face away from the interlo-
cking safety arm.
Step 4:
Raise the safety locking arm straight up and lock into the
two grooves on either side of the juicer cover. The safe-
ty locking arm should now be in a vertical position and
locked into place on top of the juicer cover (4).
IMPORTANT:
If the safety locking arm is not in the right position the motor will not
start moving. Secure the safety arm by lifting it into the two grooves of the cover.
2
1
3
4
Summary of Contents for Design Juice
Page 32: ...32...