Garmin G3X Touch, Pilot'S Manual

Page: 335 / 470

Garmin G3X Pilot’s Guide 190-01115-00 Rev. K
313
AFCS
System
Overview
Flight
Instruments
EIS
CNS
Interface
GPS
Navigation
Flight
Planning
Hazar
d
Avoidance
Additional
Featur
es
AFCS
Annun/Alerts
Appendix
Index
Control Pressed
Modes Selected
Lateral Vertical
NAV Key Navigation**
GPS
VOR
LOC
BC
Pitch Hold (default) PIT
HDG
Key Heading Select HDG Pitch Hold (default) PIT
LVL Key Level Hold LVL Level Hold LVL
*Valid VNV flight plan must be entered before
VNV
Key press activates flight director.
**The selected navigation receiver must have a valid VOR or LOC signal or active GPS course before
NAV
or
APR
Key press activates flight director.
Flight Director Activation (GMC 305)
FLIGHT DIRECTOR MODES
Flight director modes are normally selected independently for the pitch and roll axes.
Unless otherwise specified, all mode keys are alternate action (i.e., press on, press off).
In the absence of specific mode selection, the flight director reverts to the default pitch
and/or roll modes.
Armed modes are annunciated in white and active in green in the AFCS Status Box.
Under normal operation, when the control for the active flight director mode is pressed,
the flight director reverts to the default mode(s) for the axis(es). Automatic transition
from armed to active mode is indicated by the white armed mode annunciation moving
to the green active mode field and flashing for 10 seconds.
If the information required to compute a flight director mode becomes invalid or
unavailable, the flight director automatically reverts to the default mode for that axis.
A flashing yellow mode annunciation and annunciator light indicate loss of sensor
(ADC) or navigation data (VOR, LOC, GPS, VNAV) required to compute commands.
When such a loss occurs, the system automatically begins to roll the wings level (enters
Roll Hold Mode) or maintain the pitch angle (enters Pitch Hold Mode), depending on
the affected axis. The flashing annunciation stops when the affected mode key is
pressed or another mode for the axis is selected. If after 10 seconds no action is taken,
the flashing annunciation stops.