92
AQUAMAP™ 10x2/12x2 SERIES
Contour
: Sets an alarm to sound when the transducer detects a suspended
target within the specified depth from the surface of the water and from the
bottom.
Fish
: Sets an alarm to sound when the device detects a suspended target.
•
sets the alarm to sound when fish of all sizes are detected.
•
sets the alarm to sound only when medium or large fish are
detected.
•
sets the alarm to sound only when large fish are detected.
Weather Alarms
Before you can set weather alarms, you must have a compatible AQUAMAP
connected to a weather device, such as a GXM™ device, and have a valid
weather subscription.
1
Select
Settings
>
Alarms
>
Weather Alarms
.
2
Turn on alarms for specific weather events.
Fuel Alarm
Before you can set a fuel level alarm, a compatible fuel flow sensor must be
connected to the AQUAMAP.
You can set an alarm to sound when the total amount of remaining onboard
fuel reaches the level you specify.
1
Select
Settings
>
Alarms
>
Fuel
>
Total Fuel Onboard
>
On
.
2
Enter the remaining amount of fuel that triggers the alarm, and select
Done
.
My Vessel Settings
NOTE:
Some settings and options require additional charts or hardware.
Select
Settings
>
My Vessel
.
Depth and Anchoring
: Allows you to enter information about the keel and
the anchor.
Temp. Offset
: Allows you to set an offset value to compensate for the water
temperature reading from a NMEA 0183 water-temperature sensor or a
temperature-capable transducer.
Calibrate Water Speed
: Calibrates the speed-sensing transducer or sensor.
Fuel Capacity
: Sets the combined fuel capacity of all the fuel tanks on your
vessel.
Vessel Type
: Enables some AQUAMAP features based on the boat type.
CZone™
: Sets the digital switching circuits.
System Profiles
: Allows you to save your system profile to a memory card
and import system profile settings from a memory card. This can be
helpful for charter or fleet vessels, and for sharing your setup information
with a friend.
Setting the Keel Offset
You can enter a keel offset to compensate the water depth reading for the
transducer installation location. This allows you to view the depth of the water
below the keel or the true depth of the water, depending on your needs.
If you want to know the water depth below the keel or the lowest point of your
boat and the transducer is installed at the water line or anywhere above the
end of the keel, measure the distance from the transducer location to the keel
of the boat.
If you want to know the true water depth and the transducer is installed below
the water line, measure the distance from the bottom of the transducer up to
the water line.
NOTE:
This option is only available when you have valid depth data.
1
Measure the distance:
• If the transducer is installed at the water line
1
or anywhere above the
end of the keel, measure the distance from the transducer location to
the keel of the boat. Enter this value as a positive number.
• If the transducer is installed at the bottom of the keel
2
and you want
