Furuno FCV-2100, Installation Manual

Page: 43 / 59

3. INITIAL SETTINGS
3-15
2. Select the [Stabilization] menu from the [System] menu.
The [Stabilization] menu appears.
3. Set [Stabilization] to [On] to enable the stabilization mode.
Turn this function on when seas are rough, to get stable pictures regardless of sea
conditions. When heaving stabilization is turned on, the symbol (
) appears at
the “Advance” header on the screen.
4. Select the model of Satellite Compass
™
from the list on menu.
When you select other than ‘manual’, go to step 6.
5. Set the delay time between 0 and 1000 ms.
6. Set the antenna position for the Satellite Compass
™
.
• TD fore-aft: Distance (m) from antenna to transducer on the fore-aft line. Enter
a positive value for a fore-side transducer, a negative value for an aft-side trans-
ducer. (-100.0 to +100.0m)
• TD port-stbd: Distance (m) from antenna to transducer on the port-stbd line. En-
ter a positive value for starboard-side transducer, a negative value for a port-
side transducer. (-100.0 to +100.0m)
• ANT TD height: Vertical distance (m) between the antenna and the transducer.
(0.0m to 110.0m)
7. Select the [OK] to close the menu.
Note: For the heaving feature, set the SC-30/50/110 Satellite Compass
™
output as
follows. Refer to respective operator’s manual for setting details.
Feature SC-50/110 (Data out setting) SC-30 (IF-NMEASC setting)
Sentence ATT, HVE ATT, HVE
Baud rate 38400 bps 38400 bps
Cycle 25 ms 25 ms
xx.xx
SC-30/50/110
FORE (+) / AFT (-) FORE (+) / AFT (-)
Transducer Transducer
PORT(-) PORT(-)
Transducer
Antenna
[Height] [Height]
STBD(+) STBD(+)