Furuno FCV-2100, Installation Manual

Page: 28 / 59

2. WIRING
2-14
7. Reattach the WAGO connector.
Fasten the drain wire terminal lug to the chassis with a binding screw.
8. Set the gasket assembly and pack them into the seal nut.
9. Adjust the cable length then fasten the seal nut to fix the
cable.
Tighten the seal nut leaving approx. 3 mm gap between
the seal nut and super gland fixing nut.
10. Close the cover of the transceiver unit.
2.3 Data Sentences
This equipment can input/output the following NMEA data sentences.
Data I/O Sentence
Time, position Input GNS>GGA>GLL
Course over the ground (COG) and
speed over the ground (SOG) Input VTG
Water speed and heading Input VHW
Time and date Input ZDA
Water depth Output DBS, DBT, DPT
Water temperature Input/Output MTW
Target position Output TLL
Proprietary sentences Output SDafl, SDbtm, SDes1, SDes2,
SDesd, SDflg, SDmrk, pidat
Fasten the terminal lug
with a binding screw.
Insert the WAGO
connector to TB2
Gap