Field
Description
Create NAT Policy
Specify whether Network Address Translation (NAT) is to be ac-
tivated.
The function is activated with
Enabled
.
The function is enabled by default.
Local IP Address
Only if IP Address Mode =
Static
Enter the static IP address of the connection partner.
Route Entries
Only if IP Address Mode =
Static
Define other routing entries for this connection partner.
Add a new entry with Add.
•
Remote IP Address
: IP address of the destination host or
network.
•
Netmask
: Netmask of Remote IP Address. If no entry is
made, your device uses a default netmask.
•
Metric
: The lower the value, the higher the priority of the
route (possible values
0
...
15
). The default value is
1
.
The Advanced Settings menu consists of the following fields:
Fields in the Advanced Settings menu
Field
Description
Block after connection
failure for
Enter the wait time in seconds before the device should try
again after an attempt to set up a connection has failed. The de-
fault value is
60
.
Maximum Number of Di-
alup Retries
Enter the number of unsuccessful attempts to setup a connec-
tion before the interface is blocked.
Possible values are
0
to
100
.
The default value is
5
.
Authentication
Select the authentication protocol for this connection partner.
Select the authentication specified by your provider.
Possible values:
10 WAN
Funkwerk Enterprise Communications GmbH
280
bintec R1xxx/R3xxx/R4xxx
