Field
Description
•
Netmask
: Netmask for Destination IP Address.
•
Metric
: The lower the value, the higher the priority of the
route (possible values
0...15
). The default value is
1
.
IP Assignment Pool
Only if IP Address Mode =
Provide IP Address
Select an IP pool configured in the WAN -> In Dialup -
> IP Pools menu. If an IP pool has not been configured here
yet, the message
Not yet defined
appears in this field.
The Advanced Settings menu consists of the following fields:
Fields in the Advanced Settings menu
Field
Description
Block after connection
failure for
Enter the wait time in seconds before the device should try
again after an attempt to set up a connection has failed.
The default value is
300
.
Maximum Number of Di-
alup Retries
Enter the number of unsuccessful attempts to setup a connec-
tion before the interface is blocked.
Possible values are
0
to
100
.
The default value is
5
.
Usage Type
If necessary, select a special interface use.
Possible values:
•
Standard
(default value): No special type is selected.
•
Dialin only
: The interface is used for incoming dialup
connections and callbacks initiated externally.
•
Multi-User (Dialin only)
: The interface is defined as
multi-user connection partner, i.e. several clients dial in with
the same user name and password.
Authentication
Select the authentication protocol for this PPTP partner.
Possible values:
•
PAP/CHAP/MS-CHAP
(default value): Primarily run CHAP, on
denial, the authentication protocol required by the PPTP part-
Funkwerk Enterprise Communications GmbH
10 WAN
bintec R1xxx/R3xxx/R4xxx
273
