Fukuda Denshi DS-8400, Service Manual

Page: 199 / 274

9-31
Telemeter (HLX-801)

The data cannot be received at the telemetry center.
Cause 1
The channel ID or group ID is not corresponded with the telemetry receiver.
Solution
Set the correct channel ID and group ID.
Cause 2
The HLX connection setting is incorrect.
Solution
Press the [Menu]>[Initial Settings]>[System]>[Other]>[HLX Connection] keys.
If connected to internal port, select [Internal Port].
If connected to COM port, select [COM Port].
After the setting, make sure that the set channel is displayed as "CHxxxx" at the upper left of the screen.

The impedance respiration waveform cannot be received at the telemetry center.
Cause 1
[CO
2
] is selected for "RR/APNEA Alarm Source" on the RESP setup menu.
Cause 2
[Ventilator] is selected for "RR/APNEA Alarm Source" on the RESP setup screen.
Solution
Select [Impedance] for "RR/APNEA Alarm Source" on the RESP setup menu.

The BP waveform of 100 mmHg and above cannot be properly received.
Cause
The BP waveform and scale are not the same.
Solution
When the BP waveform is above 100 mmHg, set the BP scale above 100 mmHg.

<Check HLX Conn.> is displayed.
Cause
The connection with the HLX is interrupted.
Solution
Check the connection between the HLX and DSC-8410.
Check if [HLX] is set for the corresponding port under [Initial Settings] > [External Device] > [Main Unit HP-800].

<HLX Ver.> is displayed.
Cause
Installation has failed.
Solution
Check the software version of the HLX.
If "HLX-801 V99-99" is displayed, perform the installation again.
If the software version of "HLX-501 V01-09" or older is displayed, contact Fukuda Denshi.