86
SPARC Enterprise T5120 and T5220 Servers Product Notes • April 2010
6598381
In rare circumstances, the PCIe interface unit
(PIU) might issue a spurious error interrupt.
For examples, see
.
Note - Fixed in System Firmware 7.1.6.d or later.
These events are harmless and can be ignored.
You can also update the System Firmware to the
latest version to avoid encountering this issue.
6611700
(6601900)
When the OpenBoot PROM is set to
input-
device=keyboard
, you might see the
following warning message when the system
host is powered on or reset:
No keyboard support found
A U.S. keyboard will work properly.
International keyboards (French, German, and
so on) might behave as U.S. keyboards.
Note - Fixed in System Firmware 7.1.6.d or later.
Do not use USB keyboards. Instead, use a virtual
console by setting the
input-device
variable to
virtual-console
.
You can also update the System Firmware to the
latest version to avoid encountering this issue.
6602913
IPMI power off or power cycle operations might
fail.
Note - Fixed in System Firmware 7.1.6.d or later.
Repeat the IPMI power off, or power-cycle
operation, or use one of the other available
interfaces to perform this operation.
You can also update the System Firmware to the
latest version to avoid encountering this issue.
6604305
During system initialization, memory might not
be detected, and the following error is reported:
ERROR: MB/CMP0/BR3/CH0/D0 must be
populated.
Rarely, the probing of DIMMs fails due to ILOM
simultaneously updating DIMM information.
When the DIMM probing fails, the host either
boots with a reduced memory configuration, or
fails to boot. This situation is not likely to
happen when the service processor (SP) is reset,
because the DIMMs are probed before ILOM
starts dynamic
fruid
updates. This issue is
most likely to occur when the host is being
repeatedly powered on and off without resetting
the SP.
Note - Fixed in System Firmware 7.1.6.d or later.
Power off the host, reset the SP, and power on the
host.
You can also update the System Firmware to the
latest version to avoid encountering this issue.
6612687
Repeated attempts to show or set the serial port
properties of the host port might cause the
ILOM CLI to hang and become unresponsive.
Note - Fixed in System Firmware 7.0.9 or later.
Do not configure the host serial port properties
from the service processor. Instead, set the
properties from the Solaris OS.
If the ILOM CLI hangs, you must reset the system
by power cycling the AC power.
TABLE A-3
Fixed Firmware, ILOM, POST, and SP Issues
(Continued)
CR
Description
Workaround
