76
Chapter 4 Operations after OS Installation
5
Complete the settings as follows:
1. In the [Write debugging information] section, select the memory dump file type.
• Complete memory dump
The whole system memory information is recorded to the memory dump file.
• Kernel memory dump
Only kernel memory is recorded to the memory dump file.
• Small memory dump (64KB)
Minimum information is recorded to the memory dump file.
Each time a fatal error occurs, a new file is created in the directory specified in [Small
dump directory].
2. In [Dump file] or [Small dump directory], specify the directory to save the memory
dump file, with its full path.
For kernel memory dump or complete memory dump, when you check the box of the
[Overwrite any existing file], debugging information is overwritten to the specified file
every time.
6
Click [OK] to close the [Startup and Recovery] window.
7
Click [OK] to close the [System Properties] window.
8
Restart the system.
The setting is enabled after the system restarts.
Paging file setting
Set up the paging file according to the following procedures.
1
Log on to the server with the administrator account.
2
Check the free space of the drive where the system has been installed.
Check the required free space according to "
Checking hard disk free space" (
If the drive has insufficient free space, refer to "
Cannot collect the memory dump" (
3
Click [Start] – [Control Panel] – [System].
The [System Properties] window appears.
4
Click the [Advanced] tab and click [Settings] in [Performance].
The [Performance Options] window appears.
Summary of Contents for PRIMERGY RX600 S4
