Fujitsu PRIMERGY RX600 S4, User Manual

Page: 50 / 230

50
Chapter 2 Checking before OS Installation
„
Display of onboard LAN
Display of an onboard LAN on the OS is as below when OS installation performs with ServerStart.
„
Adapter numbers
For ServerStart, onboard multiple LAN adapters (network adapter) can be configured with OS
installation wizard.
To configure multiple LAN cards, select the adapter numbers in order of Adapter 1 and Adapter 2, and
enter settings for each adapter. Note that the order of adapter numbers is not necessarily the same as the
order of slots for the installed LAN adapters. This means that the setting for Adapter 1 is not always
applied to the onboard LAN. After installing the OS, check the LAN adapters to make sure that they are
configured as intended.
„
Setting up the printer
ServerStart does not support setup of printers. Perform installation after setup is completed.
2.3.4 Automatic Driver Installation with ServerStart
ServerStart supports automatic driver installation for the following expansion cards.
table: Display of onboard LAN
LAN port
Property on
My Network
LAN device name
Onboard LAN Local Area Connection
Intel
®
PRO/1000 EB Network Connection with I/O Acceleration
I/O riser card LAN Local Area Connection
Intel
®
82575EB Gigabit Network Connection
table: Automatic driver installation
Onboard controller or product name Product ID Bus
Onboard IDE/SATA
– –
Onboard LAN
– PCI-E
I/O riser card (standard)
– PCI-E
Onboard VGA
–
PCI
SAS array controller card (standard)
– PCI-E
Eth. Ctrl 1x1Gbit PCI-E 1000-BASE-T PG-289
PCI-E
Eth. Ctrl 1x1Gbit PCI-E 1000BASE-SX PG-288 PCI-E
Eth. Ctrl 2x1Gbit PCI-E 1000-BASE-T PG-2861 PCI-E
SAS RAID Ctrl PG-244C PCI-E
SCSI Ctrl U320 PG-2281 PCI-E
Fibre Channel Controller PG-FC202 PCI-E