Fujitsu PRIMERGY RX2530 M1, Upgrade And Maintenance Manual, Page: 273 / 372

RX2530 M1
Upgrade and Maintenance Manual 273
13 Front panel
Safety notes
V
CAUTION!
●
When inserting the front panel into the server, ensure not to pinch or
strain any connected cables.
●
Circuit boards and soldered parts of internal options are exposed and
can be damaged by static electricity. Always discharge static build-up
(e.g. by touching a grounded object) before handling electrostatic-
sensitive devices (ESDs)
●
Do not touch the circuitry on boards or soldered parts. Hold circuit
boards by their metallic areas or edges.
●
For further information, please refer to chapter "Important
information" on page 33 .
13.1 Basic information
The server’s chassis ID is stored on both the front panel and the system board.
After replacing the front panel, it is necessary to program the ChassisID prom
of the front panel.
Beside the CPU temperature sensor and housing temperature sensor provided
on the system board, an ambient temperature sensor is also included on the
front panel. In case of a defective ambient temperature sensor, please replace
the front panel.
Front panel module
The front panel module consists of a holder and a front panel board. These
components are already pre-assembled. The USB connector of the front USB
cable must be installed in the dependant recesses of the holder. As an option
the holder can be equipped with a front VGA connector.
Front panel on QRL (10 x 2.5-inch HDD configuration)
The front panel on QRL (Quick Release Lever) is only available for the servers
with a 10 x 2.5-inch HDD configuration. The front panel is mounted on the right
side ear. A flat cable is used for connection to the system board.