S e c t i o n F o u r
82
To Remove a Memory Upgrade Module:
1. Perform steps 1 through 5 of
To Install a
Memory Upgrade Module.
2. Pull the clips sideways away from each side
of the memory upgrade module at the same
time.
(Figure 4-14.)
3. While holding the clips out, remove the
module from the slot by lifting it up and
pulling towards the rear of your notebook.
(Figure 4-14.)
10. Replace the cover by hooking the tabs
under the rear edge of the compartment
opening and tilting down until flush with
the bottom of your notebook.
11. Replace the screw.
The memory upgrade module is not something
you routinely remove from your notebook.
Once it is installed, you can leave it in place
unless you want to increase system
memory capacity.
C A U T I O N
Before you install or remove the memory
upgrade module, save changes and close
all files and turn power off to your note-
book. (
See Power Off on pages 21-22.
)
Figure 4-14 Removing a Memory Upgrade Module
Figure 4-13 Installing a Memory Upgrade Module
4. Store the memory upgrade module in a
static guarded sleeve.
5. Replace the cover by following the instructions
in steps 10 and 11 of the instructions for To
Install a Memory Upgrade Module, or install
a new memory upgrade module and then
replace the cover by following the instructions
in steps 7 through 11 of the instructions
To Install a Memory Upgrade Module.
Summary of Contents for Lifebook E360
Page 6: ...T a b l e o f C o n t e n t s ...
Page 9: ...LifeBook E Series from Fujitsu P r e f a c e ...
Page 142: ...I n d e x ...
