Fujitsu Lifebook E360, Manual

Page: 89 / 147

Four
U s e r I n s t a l l a b l e F e a t u r e s
L i f e B o o k E S e r i e s f r o m F u j i t s u
79
C A U T I O N
The internal modems on all Fujitsu
E Series notebooks from Fujitsu PC
Corporation are not qualified for use
with telephone systems outside the
United States and Canada and may
not operate in other countries.
pushing in until it is seated, then tighten the
hold-down screw on each end of the connector.
(See Figure 1-10 on page 10.)
C A U T I O N
Pressing
F10
while holding down the
Fn
key allows you to change your selection
of where to send your display video. Each
time you press the combination of keys
you will step to the next choice. The
choices, in order, are: built-in display
panel only, external monitor only, or both
built-in display panel and external monitor.
MOUSE, KEYBOARD OR KEYPAD
Make sure the connector on your device is
the correct PS/2 type. Align the arrow on the
connector to point to the bottom of your note-
book and push it in until the connector seats.
A mouse, keyboard or keypad may be installed
and automatically recognized by your notebook
without restarting or changing setups.
(See Figure 1-10 on page 10.)
EXTERNAL MONITOR
You may install an external monitor on the
external monitor port on the rear panel of your
notebook. Make sure that the wide side of the
connector is up and attach it to the port by
THEFT PREVENTION LOCK
A physical security system lock can be installed
on the right side of your notebook.
(See Figure
1-9 on page 9 for the location of the lock slot.)
Simply insert the key end of your security
system in the slot, rotate 90 degrees and lock.
EXTERNAL INSTALLATION OF THE
MODULAR FLOPPY DISK DRIVE
To install the Modular Floppy Disk Drive
externally, you must mount the Modular
Floppy Disk Drive in the external adapter
and attach the external adapter to the
connector on your notebook.
To connect the Modular Floppy
Disk Drive externally:
1. Close all files and exit all applications.
2. Mount the Modular Floppy Disk Drive in
the external adapter by aligning the connec-
tor ends and pushing the drive into the
external adapter until it clicks into place.
3. Open the external floppy disk drive port
cover on the left side panel of your note-
book,
(see Figure 4-11) , by gently pulling
on the right side of the cover and then
tilting it open.