Fujitsu Lifebook E360, Manual

Page: 80 / 147

Removing a Device in Multi-function
Bay 1 or 2 When the System is Off.
1. Close any open files and shut down.
2. Slide the release latch at the left rear corner
of the Multi-function Bay toward the outer
edge of your notebook.
3. Slide the device forward until the unit is clear
of the compartment. This will require some
force. Use the finger ridge on the bottom of
the device.
S e c t i o n F o u r
70
C A U T I O N
Be careful aligning and seating modules
in the bay. If the fit is incorrect you may
damage the bay or the module. If the
module does not move easily, remove
it, and check for dirt or foreign objects.
It will require a firm push to latch the
module in place.
The Lithium ion battery included with your
notebook can power your notebook from either
bay. Your notebook also supports a dual battery
configuration with a Lithium ion battery in
both bays at the same time. (The second battery
is optional.)
Figure 4-2 Removing and Installing a
Device in Multi-function Bay 1
C A U T I O N
The LifeBook E Series notebook does not
support multiple floppy disk drives, but
has two different places to install one.
Installing a Device in Multi-function
Bay 1 or 2 When the System is Off.
1. Orient the item to be installed with the fin-
ger ridge away from the body of your note-
book and the connector toward the body of
your notebook.
2. With the module connector toward the back
of your notebook align the grooves on the
side of the device with the tracks in the side
of the bay.
(Figure 4-3.)
3. Slide the module toward the back of your
notebook until it clicks into place.
Removing a Device in Multi-function
Bay 1 or 2 Using Tioman Hot Swap.
1. Close any open files on the removable
device(s) that you plan to eject from
the computer.
2. Right-click on either 'Tioman Taskbar Icon'
to display its menu.
3. Select the 'Swap Devices' menu.