- (05-57) -
SY
ST
EM
DE
SIGN
SY
ST
EM
DE
SIGN
INDOOR UNIT (setting by wired remote controller)
6-4.
The function settings of the control of the indoor unit can be changed by this procedure
●
according to the installation conditions. Incorrect settings can cause the indoor unit
malfunction.
After the power is turned on, perform the “FUNCTION SETTING” according to the
●
installation conditions using the remote controller.
The settings may be selected between the following two: Function Number or Setting
●
Number.
Settings will not be changed if invalid numbers or setting numbers are selected.
●
This function cannot be used on the secondary units.
●
PREPARATION
1) Turn on the power to the Outdoor unit.
By turning on the power indoor units, so make sure the piping air-tight test and vacuuming have been
●
conducted before turning on the power.
Also check again to make sure no wiring mistakes were made before turning on the power.
●
Indoor
units
Outdoor unit
Breaker ON