H3-32
006-252-05
06.30.01 FM3040
FM-DP L
Service Manual
H3-32
MAINTENANCE 3. TROUBLESHOOTING
Error code
Error name
Significance
Probable cause and remedy
Detailed
information format
02A0
Tray 1
Lock sensor error
Attempted to lock tray 1, but SA7 did
not become OPEN.
The following motor/sensor/part may be faulty.
Correct according to the troubleshooting procedure for this error
code in "3.1.4 Troubleshooting Flow".
SA7/SOLA1
2-1-A
2-2-A
02A1
Tray 2
Lock sensor error
Attempted to lock tray 2, but SB7 did
not become OPEN.
The following motor/sensor/part may be faulty.
Correct according to the troubleshooting procedure for this error
code in "3.1.4 Troubleshooting Flow".
SB7/SOLB1
2-1-B
2-2-A
0300
Config file load error
Failed to open/load the configuration
file. (The file did not exist, etc.)
The configuration file on the memory card is damaged. Or
malfunction of the memory card.
1. Re-install in the full install mode.
2. Replace the CPU board.
None
0311
Sorting condition setting
file description
contradiction error
The contents of the sorting conditions
setting file are abnormal.
The descriptive contents of the external file are incorrect.
1. Correct the contents while referring to the detailed
information format, reload the file from the M-Utility, and
reset.
3-0-C
0312
(*1)
Fatal error following LD
malfunction
One LD has malfunctioned.
• Malfunction of LD
• Faulty cable connector
• Malfunction of SCN board
None
0320
Temperature control
system subsystem
initialization error
Failed to initialize the temperature
control system of the printer subsystem.
Malfunction of the heater thermistor
1. Check the connectors related to the heater thermistor, etc.
2. Replace the heater thermistor.
3-0-A
0321
CH Def. Value film size
error
The contents of the version information
file were abnormal when starting the
equipment.
The specifications of the system parameter and input CH
initialization setting film size are not matching.
1. Re-set the film size using M-Utility.
2. Replace the memory card, re-install in the full install mode,
and read the individual data.
3-0-B
0322
No mounted tray error
Both trays are not mounted.
Incorrect file size setting of the tray.
1. Correct the tray file size setting from the M-Utility.
None
0323
Tray disabled error
The tray is disabled.
The tray is set to the disabled state due to malfunction.
None
0324
Tray empty error
No tray mounted.
Mount the tray properly.
None
1. Check the cable connector.
2. Check the polygon. (by M-Utility)
3. Replace the SCN board.
4. To use the remaining LD temporarily, select “Enable” at the
[ContinuePrnt on Error] setting of the [System Management]-
[System Config.]-[Set parameters] of the M-Utility.
*1: Main unit software version B01 or later.