FujiFilm FM-DP L, Service Manual, Page: 117 / 380

H3-74
006-252-05 06.30.01 FM3040
FM-DP L
Service Manual
H3-74
MAINTENANCE 3. TROUBLESHOOTING
Error code Error name Significance Probable cause and remedy
Detailed
information format
1CE6
FD sector ID error
The sector ID and specified IDR
contents did not match in the READ-
DIAG results. 1. Replace with an appropriate FD.
2. Replace the FDD.
3. Replace the CPU board.
None
1CE7
FD IDAM detection error Cannot find the Data Address Mark.
1. Replace with an appropriate FD.
2. Replace the FDD.
3. Replace the CPU board.
None
1CEF
FD error
Detected an FD error other than the
above.
1. Replace with an appropriate FD.
2. Replace the FDD.
3. Replace the CPU board.
None
1D01
(*3)
IM file related error
Failed in IM (image memory)
reading/writing. Malfunction of the MTH board.
1. Replace the MTH board with a normal one.
*A
1D02
(*3)
LANM error
Error has occurred in data exchange
between the equipment and LAN board.
None None
1D03
(*3)
LAN error
The LAN board software has detected
an error.
None None
1D04
(*3)
Sequence error Message timeout
Internal communication timing error. No correction required if
no abnormal symptoms are seen.
C000:
No response
from LAN
C001:
No response
from LANM
1F06
~1F7F
FD error
(File system)
Detected a FD file system error.
1. Replace with an appropriate FD.
2. Replace the FDD.
3. Replace the CPU board.
None
1FFF
(*2)
Memory card file format
error Failed in various controls of the memory
card.
Format error of a file in the memory card.
1. Return the file format to the correct format.
2. Load the saved file from the FD.
None
2219
SG3, SG4 malfunction
(Optional)
Attempted to switch the changeover
guide plate to the side position during
initialization, but both SG3 and SG4
remained CLOSE. The following motor/sensor/part may be faulty.
Correct according to the troubleshooting procedure for this error
code in "3.1.4 Troubleshooting Flow".
SG3/SG4/SOLG1
2-1-C
2-2-A
*2: Main unit software version B02 or later.
*3: Main unit software version B03 or later.
*A: E000; FTBL uninitialized, E001; FTBL is currently used, E0002; IM read error, E0003; IM write error, E004; IM full,
E005; No IM files