25
Telephone Application Setup.
If using any of the telephone based functions, (e.g.
Answerphone, Voice Dialler, Remote Phone Access &
Control etc) the Dial Method must be set according to
the exchange type, (i.e. Pulse or Tone/DTMF).
Voice Dialler
Page 33
1) set Dial Method
2) set Dial Mode = “Voice Dialler”
3) set Voice Dialler Phone Numbers
4) set Dial Sequence
5) record Alarm Messages
6) set Call Attempts
Remote Manager
Page 40
1) set Dial Method
2) set Dial Mode = “Remote Manager”
3)
set Remote Manager Phone Numbers
4) set System ID Code
5) set Call Attempts
Answerphone
Page 39
1) set Dial Method
2) set Rings to Answer Phone
3) set Answerphone Status = ON
4) record Greeting Message
Latch Key
Page 38
1) set Dial Method
2) set Latch Key Status =
“ON” or “Selected-Users”
3) enable users if “selected users”
chosen
4) set Latch Key Phone Numbers
5) record User ID Message(s)
USER SETUP
This menu allows the 4 digit User Access Codes to be
configured for each user. The general users (1-6) may
also record a 4 second message to be used with the
Latch Key feature.
Note:
For the Latch Key feature to operate correctly
the “Dial Method” (see System Setup) and the items
within the Latch Key Setup menu must be correctly set
and programmed.
Scroll through the top level programming menu until
’1. USER SETUP
’ is displayed and press .
Note:
After configuring all required users, press to
return to the top level of programming menu.
see SYSTEM
SETUP menu
see VOICE
DIALLER
SETUP menu
see SYSTEM
SETUP menu
see REMOTE
MANAGER
SETUP menu
see SYSTEM
SETUP menu
see ANSWER
PHONE
SETUP menu
see
LATCH-KEY
SETUP menu
see SYSTEM
SETUP menu
see USER
SETUP menu
Master User Access Code
8-1 Date
DD/MM/YY 000
8-2 Time
HH/MM/SS
PROGRAM MODE
Code:
7. PART ARM
SETUP
9. LATCHKEY
SETUP
8. TIME & DATE
SETUP
Enter new system line
HH/MM/SS
STANDBY MODE
Save & exit
Exit without saving
User 2
User 3
User 4
User 5
User 6
:1 Access Code
xxxx
Enter Access
Code:
:2 Record
User Message
:3 Replay
User Message
1-1 USER 1 SETUP
:1 Access Code
xxxx
1-7 MASTER USER
SETUP
PROGRAM MODE
Code:
Start...
YES->1
NO->3
1. USER SETUP
Enter Access
Code:
