28
Scroll through the menu until ‘2-2-1 Status’ (and
the current setting) is displayed.
To change the setting press .
Press to enable the Siren, or
Press to disable the Siren.
Siren Duration
Default setting: 180 seconds
Scroll through the menu until ‘
2-1-2 Time
’ (and the
current setting) is displayed.
To change the setting press .
Enter the required Alarm Duration in units of
10 seconds. e.g. enter 6 for a 60 seconds
alarm duration (max. setting 60, i.e. 600
seconds / 10 minutes).
Press to save and exit, or
Press to exit without saving.
Press to return to top level System
Setup menu.
Note:
Following an alarm, the Siren will continue to
sound until either the system is Disarmed; or the Alarm
Duration time expires. If the “3 minute alarm time limit”
of the Siren is enabled, then the Siren will shut down
after 3 minutes even if the Control Panel siren is still
sounding.
WIREFREE SIREN
Allows the wirefree siren to be enabled or disabled.
Default setting: ON
Scroll through the menu until ‘
2-3 Wirefree Siren
’ (and
the current setting) is displayed.
To change the setting press .
Press to enable the Solar Siren, or
Press to disable the Solar Siren.
JAMMING DETECTION
Allows the jamming detection in the control panel to be
enabled or disabled.
Default setting: OFF
Scroll through the menu until ‘
2-4 RF Jamming
Detection
’ (and the current setting) is displayed.
To change the setting press .
Press to enable Jamming Detection, or
Press to disable Jamming Detection.
CONTROL PANEL BACK LIGHT
This controls how long the display backlight will remain
illuminated for after a key is pressed.
Default setting: 10 seconds
Scroll through the menu until ‘
2-5 Back Light
’ (and the
current setting) is displayed.
To change the setting press .
Scroll through the menu options, until the required
setting is displayed.
Press
to save and exit, or
Press to exit without saving.
ALARM RELAY
This controls the operation of the NO/NC signalling
relay contacts following an alarm.
Default setting: “ON Until Disarm”
Scroll through the menu until ‘
2-6 Alarm Relay
’ (and
the current setting) is displayed.
To change the setting press .
Scroll through the menu options, until the required
setting is displayed.
Press to save and exit, or
Press to exit without saving.
ZONE LOCKOUT
If enabled, this prevents a single zone from triggering
an alarm more than 3 times before the system is
disarmed.
Default setting: ON
Scroll through the menu until ‘
2-7 Zone Lockout
’ (and
the current setting) is displayed.
To change the setting press .
Press to enable Zone Lockout, or
Press to disable Zone Lockout.
