FRIEDLAND SA5, Installation & Operating Manual

Page: 35 / 52

35
FULL ARM SETUP
The parameters in this menu control the systems Exit-
Delay period and the Entry/Exit Delay warning beeps
during Full Arm mode.
Scroll through the programming menu until ‘5. FULL
ARM SETUP’ is displayed and press .
Note: After configuring ‘Full Arm’ press to return
to the top level programming menu.
EXIT-DELAY PERIOD
Scroll through the menu until ‘5-1 EXIT-DELAY’ (and
the current setting) is displayed.
To change the settings press .
On/Off Status
Default setting: ON
Scroll through the menu until ‘5-1-1 Status’ (and
the current setting) is displayed.
To change the setting press .
Press to enable the Exit-Delay, or
Press to disable the Exit-Delay.
Delay Period
Default setting: 30 seconds
Scroll through the menu until ‘5-1-2 Delay Time’
(and the current setting) is displayed.
To change the settings press .
Enter the required delay period (10 to 250
seconds).
Press to save and exit, or
Press to exit without saving.
Press to return to top level Full Arm Setup
menu.
ENTRY-DELAY BEEPS
Allows the Entry-Delay warning beeps when activating
Full Arm to be switched ON or OFF.
Default Setting: ON
Scroll through the menu until ‘ 5-2 Entry Delay Beep ’
(and the current setting) is displayed.
To change the setting press .
Press to enable the beeps, or
Press to disable the beeps.
EXIT-DELAY BEEPS
Allows the Exit-Delay warning beeps when activating
Full Arm to be switched ON or OFF.
Default Setting: ON
Scroll through the menu until ‘5 -3 Exit Delay Beep ’
(and the current setting) is displayed.
To change the setting press .
Press to enable the beeps, or
Press to disable the beeps.
CALL ATTEMPTS
This sets the maximum number of times that the dialler
will attempt to contact each enabled telephone number
in the call routing sequence.
Default setting: 3
Scroll through the menu until ‘ 4-7 Call Attempts ’ (and
the current setting) is displayed.
To change the setting press .
Enter the required number of dial attempts (1-5).
Press to save and exit, or
Press to exit without saving.
5. FULL ARM
SETUP
PROGRAM MODE
Code:
5-3 Exit Delay
Beep: xxx
5-2 Entry Delay
Beep: xxx
Select
ON->1 OFF->3
Select
ON->1 OFF->3
5-1 EXIT Delay
xxx xxx s
5-1-1 Status
xxx
Select
ON->1 OFF->3
5-1-2 Delay Time
Enter (10-250s)
Enter (10-250s)