41
OPERATING INSTRUCTIONS
When leaving the premises, the system must be Armed.
However, before doing so, check that all windows are
closed and locked, all protected doors are closed and
PIR Detectors are not obstructed. Ensure that pets are
restricted to areas not protected by PIR Detectors.
The system has 3 arming modes, ARM, Part-Arm 1 and
Part-Arm 2. The Part-Arm modes allow for selected
zones to be left in a Disarmed state whilst the remainder
of the system is Armed.
When the system is Armed the mode being activated will
be displayed on the screen followed by the status of the
Latch Key feature. The programmed system exit-delay
will be displayed and counted down on the screen. If
exit-delay beeps are enabled the panel will beep with
the beep rate increasing in steps as the exit-delay
expires. At the end of the Exit period all active zones
will be fully Armed. By this time the user must have left
the property and closed the final protected door.
If while the system is armed a detector on an active
zone is triggered the programmed entry-delay for that
zone will be displayed and counted down on the screen.
If entry-delay beeps are enabled the panel will beep
with the beep rate increasing in steps as the entry-delay
expires. If the system has not been Disarmed when the
entry-delay expires a Full Alarm will occur. (
Note:
if the
entry-delay for the zone triggering the alarm is disabled
then an alarm will occur immediately the detector
is triggered instead). Details of the zone event that
triggered the alarm will be recorded in the Event Log.
At the end of the set alarm duration the Siren and
Control Panel alarms will stop and the system will
automatically re-Arm itself, (subject to the conditions of
the Zone Lockout feature).
Notes:
- To conserve power and maximise battery life
the PIR detector will only detect movement if there
has been no movement detected within the previous 2
minutes.
- If the Solar Siren is fitted and the 3 minute limit is
enabled then the external siren will shut down when the
programmed alarm duration expires or after 3 minutes,
whichever occurs first.
Voice Dialler
If an alarm is triggered and the Voice dialler is activated
then the first enabled phone number in the dialling
sequence will be called and the recorded alarm
message will be replayed for the programmed “Play
Time” period. The recipient should acknowledge
the message by pressing the button on their
telephone keypad to shut down the call sequence. If
an acknowledgment signal is not received, then the
next enabled number in the call sequence will be called.
The dialler will continue calling each enabled number
in turn until either all numbers in the sequence have
been dialled the set number of times or the dialling
sequence is cancelled by an acknowledged signal from
a recipient.
ARMING THE SYSTEM
The system can be set in FULL ARM mode using either
the Remote Control or the Control Panel as follows:
a.
Press on the Remote Control, or
b.
Press
on the Control Panel.
PART ARMING THE SYSTEM: PART-ARM 1
The system can be set in PART-ARM 1 mode using
either the Remote Control or the Control Panel as
follows:
a.
Press on the Remote Control, or
b.
Press
on the Control Panel.
PART ARMING THE SYSTEM: PART-ARM 2
The system can be set in PART-ARM 2 mode using
either the Remote Control or the Control Panel as
follows:
a.
Press , on the Remote Control, or
b.
Press
on the Control Panel.
DISARM
The system can be Disarmed using either the Remote
Control or the Control Panel as follows:
a.
Press on the Remote Control, or
b.
Press
on the Control Panel.
User Access Code
,
,
User Access Code
,
,
User Access Code
,
,
User Access Code