43
Press to access the Event Log, (from Standby
Mode only).
The Event Log will automatically display each event in
turn starting with the most recent. The data for each
event is shown on 2 screens with each screen being
displayed for 5 seconds.
Use and to manually scroll through the
events.
Press to return to Standby.
LEAVING A VOICE MEMO MESSAGE
To record a message at the Control Panel using the
Voice Memo facility, proceed as follows:
Press
Press to start recording.
Press to stop the recorder and skip the remaining
message time, (max. message duration is 30 seconds),
Note:
the system can only store a maximum of 6
messages, (including answerphone messages). If
there is no spare message capacity then it will not be
possible to record any message until one has been
deleted.
Messages may be accessed or deleted either at the
Control Panel (see Replay Messages) or via the
“Remote Phone Access and Control” facility.
REPLAYING AND DELETING MESSAGES
AT THE CONTROL PANEL
The presence of any unread memos or answerphone
messages is indicated on the Control Panel by the
‘MESSAGE’ LED being illuminated.
Messages may be accessed at the Control Panel as
follows:
Press
Messages are replayed in the order they are received.
Press during a message to skip to the end of the
message.
At the end of each message there will be the option
of deleting the message just heard. To delete the
message:
Press to delete the message
Press to re-confirm deletion of the message.
Note:
Press at either stage to cancel delete and
move on to the next message.
After all messages have been replayed the system will
automatically return to Standby Mode.
REMOTE PHONE ACCESS AND CONTROL
The Remote Phone Access and Control facility, if
enabled, allows you to dial into the system and recover
messages and/or to monitor/control the basic alarm
system functions.
The Control Panel will answer the call after the set
number of rings and emit 3 beeps on the phone line.
Enter a User Access Code on the telephone keypad.
A valid User Access Code will be acknowledged with 1
long beep.
An incorrect code will be acknowledged by 2 short
beeps.
If a User Access Code is not entered within 30 seconds
or is entered incorrectly 3 times then the Control Panel
will automatically disconnect the line.
Note:
If the internal answerphone is also enabled
and there is space for a message then the call will be
answered with the answerphone greeting message.
The User Access Code should be entered before the
greeting message finishes, otherwise the answerphone
message recorder will be activated.
Double Dial-In for Operation with an
External Answerphone:
If the Remote Access and Control feature is to be used
and the system is operating in conjunction with an
external answerphone then
1.
The internal answerphone will be disabled.
2.
Remote Phone Access and Control must be enabled.
3.
The number of ‘rings to answer’ for the Control Panel
must be greater than that of the external answerphone
To access the Remote System Control facility the
Control panel has a ‘double dial-in’ feature to enable
the Control Panel to pick-up the phone call before the
external answerphone cuts in. The ‘double dial-in’
procedure operates as follows:
User Access Code
,
,