Fresenius Kabi Volumat Agilia, Technical Manual

Page: 65 / 138

va05.1_001e_Eng.fm 65
Tr
oub
lesho
o
ting
5 Troubleshooting
5.1 Breakdown guide
Displayed
message
Meaning Cause Action
Door opened
alarm
 The Hall effect
sensor detects that
the door is open
 Check that the magnet is
present on the door
 Calibrate the door sensor
 Replace the door sensor
Administration
set position
alarm
 The pump does
not detect the
presence of the
safety clamp
 Check the position of the
administration set and the clamp.
Close the door.
 Check the clamp detection
opto and replace if necessary
Administration
set insertion
alarm
 Incorrect
administration set
position
 Check the administration set
position
 Check that the magnet is
present on the door
 Calibrate the door sensor
 Replace the door sensor
 At start-up:
administration set
not installed or
door opened
 Install the administration set
and close the door
OCS test failure
alarm
 The pumping
mechanism has
not managed to
raise the pressure
in the line during
the OCS test.
 Check the administration set
position
 Check the pressure sensors
calibration
 Check the integrity of the
membrane and replace it if
necessary
 Check the installation of the
administration set and its integrity
 Check the integrity of the door
 If the problem persists,
contact the Technical Service
Air bubble alarm
 The volume of
air detected in the
line exceeds the
limit
 Remove the air bubbles
present by rebooting the
administration set
 Check the air bubble size
setting
 Calibrate the air detector
 Replace the air detector
 Air bubble
detected at start-
up or in stop mode
 Remove the air bubble by
priming the administration set