Freecom ValueLoader, User Manual

Page: 28 / 88

Installing the ValueLoader
Connecting the SCSI and Power Cables
14 ValueLoader LTO Tape Autoloader User Manual
2
Attach one end of the SCSI cable (included in the accessory kit)
to one of the connectors on the rear panel of the ValueLoader.
See figure 8 .
3
Attach the other end of the SCSI cable to the connector on the
SCSI host adapter or to the connector on the previous device on
the SCSI bus.
4
If the ValueLoader is the last (or only) device on the SCSI bus,
attach the terminator to the remaining SCSI connector on the
rear panel of the ValueLoader, as shown in figure 8 . Otherwise,
attach the cable to the next device on the SCSI bus. Make sure
the last device on the SCSI bus is properly terminated.
5
Attach the power cable to the power connector on the rear
panel of the ValueLoader as shown in figure 8 .
Figure 8 Attaching
SCSI and Power
Cables
Note:
If the supplied SCSI cable does not fit the connector
on your SCSI host adapter, you either have an
incompatible SCSI host adapter, or you need to
purchase a cable adapter. For clarification, contact
your service representative or SCSI host adapter
manufacturer.